Basic Settings should be performed
on an Automatic Transmission after:
First, make sure there are no
fault codes in the Auto Trans. Then, with the key in the on position, and
engine OFF. Do not touch the accelerator pedal.
[Select]
[02 - Auto Trans]
[Basic Settings - 04]
Set Group to "000"
[Go!]
Press accelerator pedal all the
way to the floor and count out loud 3 seconds.
[Done, Go Back]
Release the accelerator pedal.
It is normal for there to
be no explicit instructions or changes on the screen when you do the above
procedure. The transmission controller does not provide any feedback that
it has been successfully performed. For 09G transmissions, Basic
Settings group 001 is used and the accelerator pedal is NOT touched.
Note: In some newer Audi vehicles,
you may find that Group 000 in Auto Trans. is unavailable. If that
is the case, you should follow this procedure:
First, make sure there are no
fault codes in the Auto Trans. Then, with the key in the on position, and
engine OFF. Do not touch the accelerator pedal.
[Select]
[01 - Engine]
[Basic Settings - 04]
Set Group to "063"
[Go!]
Press accelerator pedal all the
way to the floor and count out loud 3 seconds.
[Done, Go Back]
Release the accelerator pedal.
Automatic Transmission Fluid
temperature needs to be within a specified range when checking the fluid
level. See your Factory Repair Manual for the range for your vehicle.
[Select]
[02 - Auto Trans]
[Meas. Blocks - 08]
Set group to "005" (May be group 002 or 004 in some vehicles - again
check the Repair Manual).
[Go!]
The value in field 1 should be ATF
temp in �C.
